Product Description

Product Description

Chengda new oil fuel tanker trailer

 

Dimension(Lx W xH)(unloaded)(mm)	11950*2495*3900
Tare Weight(KG)	9000
Loading Weight( KG)	40000
Total Weight(KG)	49000
Tank capacity( CBM )	45
Volume(L)	42000
Medium	Oil
SPECIFICATION
Material	stainless steel 304
Tank thickness(mm)	5
Main beam	The height of the beam is 500 mm, upper plate is16mm,down plate is 18mm,middle plate is 10mm.
Approaching angle/Departure angle(°)	-/18
Axle Brand	FUWA 13ton axle
Axle Number	3
Compartment	3
Manholes	3
Spill Discharges	3
Walkway	on the top
Wheelbase(mm)	1320/1320
Suspension system	Leaf spring suspension
Leaf spring suspension	10/10/10 leaf spring suspension
Tire Type and quantity	12R22.5 12units
Rims	Steel
Electrical system	1. Voltage: 24v 2. Receptacle: 7 ways (7 wire harness)
Painting	Optional

 

 

 

 

 

 

 

Parts

 

Landing Gear

Heavy Duty landing gears:
As per the capacity, there are 5ton 8ton, 15ton, 20ton,25ton, 28ton, 30ton and 35ton.
As per the gearbox, there are both Gearbox inside and Gearbox outside type.
As per the operation, there are both Single-Side Operation and Double-Side Operation type.
As per the Sand Shoe, there are T-Shoe, Casting T-Shoe, S-Shoe, R-Shoe and A-Shoe.

 

King Pin Plate

 90# 3.5” trailer welding king pin
We can provide several model with different specifications. 
certification:ISO9001-2000
90# 3.5” trailer bolt connecting king pin

 

 

 

Axle

1. specifical heat-treat, low-alloy steel axle beam, it has the vitues of good synthetic performance, strong load ability and lower self weight.
2. high quality alloy solid inserted spindle, through wholy heat treatment, provide superior fatigue capability
3. high performance premiun non-asbestos brake linings, extend service life
4. easy for ABS installation
5. camshaft, matching with special seals, can ensure no entry of the grease into the brake drum, more safety
6. new tight fit hub cap have O rings, high property for sealing

 

Air Suspension

Air Suspension is a type of automotive suspension that uses air springs instead of conventional steel springs. Computer-operated vents on the air springs, suspension sensors, and an on board air compressor allow the system to maintain ride height and vary the suspension’s ride characteristics.

 

 

Packing & Delivery

 

 

 

Bulk cargo refers to bulk cargo, such as coal, grain, mineral sand and petroleum, which is not packaged on deck or cabin. The loading and unloading of this kind of goods need the corresponding dock handling equipment, and some also need special means of transport, such as tankers.
 

 

Definition: A mode of transport in which a truck with containers, a tray with a pulley, or a variety of motor vehicles are used as a cargo unit to haul into the hold of a ship and transport it. Applied disciplines: geography (first-level disciplines); economic geography (second-level disciplines) above by the national science and technology terminology examination and promulgation of the Ro-Ro Transportation refers to the use of “Ro-Ro Shipping” together with a vehicle and cargo shipping mode. The advantages are: easy handling and low cost.
 

 

Container transportation refers to a new type of high-speed and high-speed transportation which takes container as the carrier and assembles the goods into a container unit so as to use large-scale loading and unloading machinery and large-scale carrying vehicles in the field of modern circulation to carry out the loading and unloading, handling and transportation tasks, and thus to better realize the “door-to-door” transportation of goods. Efficient and efficient transportation mode.

 

Company Profile

 

 

 

With high standard machinery and automatic equipment, powerful R&D team and elite sales team, We have built long business relationship with many world famous enterprises such as SINOTRUK, SHACMAN, FAW, etc.
 

 

All the chassis are manufactured under standard process to ensure quality.

All the parts are supplied to whenever you need.
 

 

Trading  Show 

 

Chengda can provide customers with various kinds of trucks and semi-trailers, such as dump truck , tractor head, water tanker truck ,concrete mexer truck , dump trailer, fuel tanker trailer, container transport trailer, lowbed semi-trailer; or full trailer and other 40 above kinds of trailers; or tractor head from CZPT to other famous brands based on the long-term cooperation. Customers can always get a better solution of transportation from us.

 

 

Receive African and Pakistani  friends to  visit our company.

 

Negotiate product details with customers.

 

Customers visit the factory.

Certification

 

1.CCC is shorted for China Compulsory Certificates, which is similar to others certificates for product quality standardization, such as European CE system. In order to obtain the CCC certificates, the manufacturer is required to do the product testing and factory audits.
2. WMI is short for World Manufacturer Identifier. Every vehicle manufacturer all over the world has 1 unique or several WMI.

3.All the semi trailers manufactured in our factory is in conformity with quality management system standard:GB/T19001-2008 idt ISO 9001:2008.

 

FAQ

 

Q1. What is your terms of packing?

A: Generally, we pack our goods in neutral white boxes and brown cartons. If you have legally registered patent, 

we can pack the goods in your branded boxes after getting your authorization letters.

Q2. What is your terms of payment?

A: T/T 30% as deposit, and 70% before delivery. We’ll show you the photos of the products and packages 

before you pay the balance.

Q3. What is your terms of delivery?

A: EXW, FOB, CFR, CIF, DDU.

Q4. How about your delivery time?

A: Generally, it will take 30 to 60 days after receiving your advance payment. The specific delivery time depends 

on the items and the quantity of your order.

Q5. Can you produce according to the samples?

A: Yes, we can produce by your samples or technical drawings. We can build the molds and fixtures.

Q6. What is your sample policy?

A: We can supply the sample if we have ready parts in stock, but the customers have to pay the sample cost and 

the courier cost.

Q7. Do you test all your goods before delivery?

A: Yes, we have 100% test before delivery

Q8: How do you make our business long-term and good relationship?

A:1. We keep good quality and competitive price to ensure our customers benefit ;

2. We respect every customer as our friend and we sincerely do business and make friends with them, 

no matter where they come from.
 

Our Service

1. OEM Manufacturing welcome

2. Sample order MOQ 1 unit

3. We will reply you for your inquiry in 24 hours.

4. after sending, we will track the products for you once every 2 days, until you get the products. When you got the 

goods, test them, and give me a feedback.If you have any questions about the problem, contact with us, we will offer 

he solve way for you.

5. Main production :dump trailer, fuel tanker trailer, container transport trailer, lowbed semi-trailer; or full trailer tractor head ,dump truck, cargo truck, concrete mixer truck from CZPT to other famous brands based on the long
 

Contact

 

 

 

 

When your axle needs to be replaced

If you’re wondering when your axle needs to be replaced, you should be aware of these signs first. A damaged axle is usually a sign that your car is out of balance. To tell if the axle needs to be replaced, listen for the strange noise the wheels make as they move. A rhythmic popping sound when you hit bumps or turns indicates that your axle needs to be replaced. If this sounds familiar, you should visit a mechanic.

Symptoms of a broken shaft

You may notice a clicking or clanking sound from the rear of the vehicle. The vibrations you feel while driving may also indicate damaged axles. In severe cases, your car may lose control, resulting in a crash. If you experience these symptoms, it’s time to visit your auto repair shop. For just a few hundred dollars, you can get your car back on the road, and you don’t have to worry about driving.
Often, damaged axles can be caused by a variety of causes, including poor shock or load bearing bearings. Other causes of axle problems can be an overloaded vehicle, potholes, or a car accident. A bad axle can also cause vibrations and power transmission failures while driving. A damaged axle can also be the result of hitting a curb or pothole. When shaft damage is the cause of these symptoms, it must be repaired immediately.
If your car’s front axle is bent, you may need to replace them at the same time. In this case, you need to remove all tires from the car, separate the driveshaft from the transmission, and remove the axle. Be sure to double check the alignment to make sure everything is ok. Your insurance may cover the cost of repairs, but you may need to pay a deductible before getting coverage.
Axle damage is a common cause of vehicle instability. Axles are key components of a car that transmit power from the engine to the wheels. If it breaks, your vehicle will not be able to drive without a working axle. Symptoms of damaged axles can include high-speed vibrations or crashes that can shake the entire car. When it breaks down, your vehicle won’t be able to carry the weight of your vehicle, so it’s important to get your car repaired as soon as possible.
When your axle is damaged, the wheels will not turn properly, causing the vehicle to crash. When your car has these problems, the brakes won’t work properly and can make your car unstable. The wheels also won’t line up properly, which can cause the brakes to fail. Also, a damaged axle can cause the brakes to become sluggish and sensitive. In addition to the obvious signs, you can also experience the sound of metal rubbing against metal.

Types of car axles

When you’re shopping for a new or used car, it’s important to know that there are different types of axles. Knowing the year, make, model, trim and body type will help you determine the type you need. For easy purchasing, you can also visit My Auto Shop and fill out the vehicle information checklist. You can also read about drivetrains and braking systems. After mastering the basic information of the vehicle, you can purchase the axle assembly.
There are 2 basic types of automotive axles: short axles and drive axles. The axle is the suspension system of the vehicle. They carry the drive torque of the engine and distribute the weight throughout the vehicle. While short shafts have the advantage of simpler maintenance, dead shafts are more difficult to repair. They’re also less flexible, which means they need to be durable enough to withstand harsh conditions.
Axles can be 1 of 3 basic types, depending on the weight and required force. Semi-floating shafts have a bearing in the sleeve. They attach to the wheel and spin to generate torque. Semi-pontoons are common in light pickup trucks and medium-duty vehicles. They are not as effective as floating axles, but still provide a solid foundation for wheel alignment. To keep the wheels aligned, these axles are an important part of the car.
The front axle is the largest of the 3 and can handle road shocks. It consists of 4 main parts: stub shaft, beam, universal pin and track rod. The front axle is also very important as it helps with steering and handling road shocks. The front axle should be strong and durable, as the front axle is most susceptible to road shocks.
Cars use 2 types of axles: live and dead. Live axles connect to the wheels and drive the vehicle. Dead axles do not drive the wheels and support the vehicle. Those with 2 wheels have live axles. Heavy trucks and trailers use 3 or more. The number of axles varies according to the weight and load of the vehicle. This will affect which type of axle you need.

life expectancy

There are a few things to keep in mind when determining the life expectancy of an automotive axle. First, you should check for any signs of wear. A common sign is rust. If your vehicle is often driven in snow and ice, you may need to replace the axle. Also, you should listen for strange sounds from the wheels, such as rhythmic thumping.
Depending on the type of axle, your car may have an average lifespan of 70,000 miles. However, if you have an older car, the CV axles probably won’t last 5 years. In this case, you may wish to postpone the inspection. This way, you can save money on repairs. However, the next step is to replace the faulty CV shaft. This process can take anywhere from 1 hour to 3 hours.
Weaker axles will eventually break. If it were weakened, it would compromise the steering suspension, putting other road users at risk. Fortunately, proper maintenance will help extend the life of your axle. Here are some tips for extending its lifespan. A good rule of thumb is to never go over speed bumps. This will cause sudden breakage, possibly resulting in a car accident. To prolong the life of your vehicle’s axles, follow these tips.
Another thing to check is the CV connector. If loose, it can cause vibration or even breakage if not controlled. Loose axles can damage the body, suspension and differential. To make matters worse, the guard on the CV joint could tear prematurely, causing the shaft to come loose. Poor CV connections can damage the differential or transmission if left unchecked. So if you want to maximize the life expectancy of your car’s axles, consider getting them serviced as soon as possible.

The cost of repairing a damaged axle

A damaged axle may need repair as it is responsible for transferring power from the engine to the wheels. A damaged axle can cause a crash or even loss of control. Repairing an axle is much simpler than dealing with an accident. However, damaged axles can cost hundreds of dollars or more. Therefore, it is important to know what to do if you suspect that your axle may have a damaged component.
When your car needs to be replaced or repaired, you should seek the help of a professional mechanic to keep your car safe. You can save a lot of money by contacting a local mechanic who will provide the parts and labor needed to repair the axle. Also, you can avoid accidents by fixing your car as soon as possible. While axles can be expensive, they can last for many years.
The cost of repairing a damaged axle depends on the amount of repairs required and the vehicle you are driving. Prices range from $300 to $1,000, depending on the car and its age. In most cases, it will cost you less than $200 if you know how to fix a damaged axle. For those without DIY auto repair experience, a new axle can cost as little as $500. A damaged axle is a dangerous part of driving.
Fortunately, there are several affordable ways to repair damaged axles. Choosing a mechanic who specializes in this type of repair is critical. They will assess the damage and decide whether to replace or repair the part. In addition to this, they will also road test your car after completing the repairs. If you are unsure about repair procedures or costs, call a mechanic.